Hi. I recently came into posession of a Dell computer case. I would use
it, except that its switches-and-LEDs connector is proprietary. It takes
pins like are on the motherboard in that area, and would fit onto them,
except (a) the pinout is wrong; (b) it's one row too short; and (c) one
hole is blocked (#14, if my count is correct).
Where could I find a block of pins (~0.1" or ~2.7mm spacing, two columns
by at least four rows) that I can solder or screw wires to, online or
brick-and-mortar? Or, can I buy somewhere an adapter, that goes to loose
connectors for power & IDE LEDs, power & reset switches?
-- -eben ebQenW1@EtaRmpTabYayU.rIr.OcoPm home.tampabay.rr.com/hactar CANCER: The position of Jupiter says that you should spend the rest of the week face down in the mud. Try not to shove a roll of duct tape up your nose when taking your driver's test. -- Weird Al
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 20:23:35 EDT